Setup Guide

41 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
8.2.2 show vlt domain_id backup-link
This command is used to verify VLT peers are communicating on the backup link over the OOB management
network. The Destination is the management IP address of the peer. The Peer Heartbeat status
must be Up.
S5248F-Leaf1A# show vlt 127 backup-link
VLT Backup Link
------------------------
Destination : 100.67.172.37
Peer Heartbeat status : Up
Heartbeat interval : 30
Heartbeat timeout : 90
Destination VRF : default
8.2.3 show vlt domain_id mismatch
This command highlights any potential configuration issues between VLT peers. All items must indicate No
mismatch.
S5248F-Leaf1A# show vlt 127 mismatch
VLT-MAC mismatch:
No mismatch
Peer-routing mismatch:
No mismatch
VLAN mismatch:
No mismatch
VLT VLAN mismatch:
No mismatch
VLT Virtual Network Mismatch:
Virtual Network Name Mismatch:
No mismatch
Virtual Network VLTi-VLAN Mismatch:
No mismatch
Virtual Network Mode Mismatch:
No mismatch
Virtual Network Tagged Interfaces Mismatch:
No mismatch
Virtual Network Untagged Interfaces Mismatch:
No mismatch
(Output truncated)