Administrator Guide

show running-config lldp
Display the current global LLDP configuration.
Syntax
show running-config lldp
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S8420T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# show running-config lldp
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 15
multiplier 3
no disable
DellEMC#
snmp-notification-interval
Used to configure the value for the lldp notification interval, to throttle lldp notification messages.
Syntax
[no] snmp-notification-interval [seconds]
To disable this feature, use the no snmp-notification-interval command.
Parameters
seconds Enter a value from 5 to 3600 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(2.5) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6010–ON and Z9100–ON
Link Layer Discovery Protocol (LLDP) 893