Administrator Guide
Usage Information
When you enable this feature, it allows you to set the delay timer value between 1 second to 300 seconds on all
ports globally.
To disable the timer on all ports, use the no port-delay-restore command.
To disable the timer on an individual interface, use the no port-delay-restore command in the INTERFACE
mode.
NOTE: In a stacking environment, the port-delay-restore timer kicks in for each individual stack-
unit separately as it boots up.
Related
Commands
no port-delay-restore (Interface Mode) — disables delayed bring up of individual interfaces during switch
boot up.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this way is identified as a hybrid port in
report displays.
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode hybrid
command.
Defaults non-hybrid
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
The following describes the interface command shown in the following example. This example sets a port as
hybrid, makes the port a tagged member of VLAN 20, and an untagged member of VLAN 10, which becomes the
native VLAN of the port. The port now accepts:
• untagged frames and classify them as VLAN 10 frames
• VLAN 20 tagged frames
The following describes the do show interfaces command shown in the following example. This example
shows output with “Hybrid” as the newly added value for 802.1QTagged. The options for this field are:
620 Interfaces