Administrator Guide

interface
Configure a physical or virtual interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and the interface information:
• For a null interface, enter the keyword null then the slot/port information. The Null
interface number is 0.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port channel interface, enter the keywords port-channel then a number.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a physical interface.
602 Interfaces