Administrator Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, Z9000, and Z9500.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This command
displays packets for IGMP and IGMP snooping.
ip igmp snooping enable
Enable IGMP snooping on all or a single VLAN. This command is the master on/off switch to enable IGMP snooping.
Syntax
ip igmp snooping enable
To disable IGMP snooping, use the no ip igmp snooping enable command.
Defaults Disabled.
Command Modes
• CONFIGURATION
• INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information To enable IGMP snooping, enter this command. When you enable this command from CONFIGURATION mode,
IGMP snooping enables on all VLAN interfaces (except the default VLAN).
NOTE: Execute the no shutdown command on the VLAN interface for IGMP Snooping to
function.
582 Internet Group Management Protocol (IGMP)