Administrator Guide

tftp: Enter the keyword tftp: to copy from the remote file system, IPv4, or IPv6, (tftp://
hostip/filepath).
usbflash: Enter the keyword usbflash: to copy the file to or from the external USB flash.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added the nfsmount:<mount-point> parameters that
allow you to mount a remote NFS file system.
9.4(0.0) Added the compressed-config parameter.
9.3(0.1) Added the http parameter on the S6000, Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
8.4.1.0 Added IPv6 addressing support for FTP, TFTP, and SCP.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added usbflash and rpm0usbflash commands on E-Series.
7.6.1.0 Introduced on the S-Series and added the SSH port number to the SCP prompt sequence
on all systems.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
Dell EMC Networking OS supports a maximum of 100 files at the root directory level on both the internal and
external flash.
When copying a file to a remote location (for example, using Secure Copy [SCP]), enter only the keywords and
Dell EMC Networking OS prompts you for the rest of the information. For example, when using SCP, you can
enter
copy running-config scp: where running-config is the source and the target is specified in the
ensuing prompts. Dell EMC Networking OS prompts you to enter any required information for the named
destination — remote destination, destination filename, user ID, password, and so forth.
When you use the copy running-config startup-config command to copy the running configuration
to the startup configuration file, Dell EMC Networking OS creates a backup file on the internal flash of the startup
configuration.
When you load the startup configuration or a configuration file from a network server such as TFTP to the running
configuration, the configuration is added to the running configuration. This does not replace the existing running
configuration. Commands in the configuration file has precedence over commands in the running configuration.
Dell EMC Networking OS supports copying the running-configuration to a TFTP server, an FTP server, or a
remote NFS file system. For example:
58 File Management