Administrator Guide

File Management

This section contains command line interface (CLI) commands needed to manage the configuration files, as well as other file management

commands.

Topics:

• boot system

• cd

• copy

• delete

• dir

• format

• fsck flash

• mkdir

• mount nfs

• rmdir

• upgrade system

• HTTP Copy via CLI

• rename

• restore factory-defaults

• show boot system

• show bootvar

• show file-systems

• show os-version

• show running-config

• show startup-config

• show version

• upgrade

boot system

Specify the location where the Dell EMC Networking OS image used to boot the system is stored.

Syntax

boot system {gateway ip-address | stack-unit {stack-unit-number | all} {default

| primary | secondary} {ftp: | nfsmount: | system: {A: | B: | bmp-boot} | tftp:

| usbflash:}}

To return to the default boot sequence, use the no boot system command.

Parameters

gateway Enter the IP address of the default next-hop gateway for the management subnet.

ip-address

Enter an IP address in dotted decimal format.

stack-unit Enter the keywords stack-unit to specify the stack unit number.

all Enter the keyword all for all the stack units.

stack-unit-number

Enter the stack-unit number. The range is from 1 to 6.

default Enter the keyword default to specify the default Dell EMC Networking OS image.

primary Enter the keyword primary to specify the primary Dell EMC Networking OS image.

secondary Enter the keyword secondary to specify the secondary Dell EMC Networking OS

image.

system: Enter the keyword system: to use the system image file URL (system).

File Management 55