Administrator Guide
Uplink State Group: 16 Status: Disabled, Up
DellEMC#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface disabled
Uplink State Group : 1 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 3 Status: Enabled, Up
Upstream Interfaces : Gi 1/25(Up) Gi 1/28(Up)
Downstream Interfaces : Te 5/1(Up) Te 5/1(Up) Te 5/3(Up) Te 5/5(Up) Te
5/6(Up)
Uplink State Group : 5 Status: Enabled, Down
Upstream Interfaces : Gi 1/1(Dwn) Gi 1/3(Dwn) Gi 1/5(Dwn)
Downstream Interfaces : Te 5/2(Dis) Te 5/4(Dis) Te 5/11(Dis) Te 5/12(Dis) Te
5/13(Dis) Te 5/14(Dis) Te 5/15(Dis)
Uplink State Group : 6 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Gi 1/25(Dwn) Po 8(Dwn)
Downstream Interfaces : Gi 1/30(Dwn)
Related
Commands
• show running-config uplink-state-group — displays the current configuration of one or more uplink-state
groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch or router.
Syntax
uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id command.
Parameters
group-id
Enter the ID number of an uplink-state group. The range is from 1 to 16.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10.0.2 Introduced on the Z9100–ON.
9.8(2.0) Introduced on the S3100 series.
9.10(0.0) Introduced on the S3148.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
1556 Uplink Failure Detection (UFD)