Administrator Guide

Version Description
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
This command triggers updates of the main RIP routing tables.
debug ip rip
Examine RIP routing information for troubleshooting.
S3048–ON
Syntax
debug ip rip [interface | database | events [interface] | trigger]
To turn off debugging output, use the no debug ip rip command.
Parameters
interface (OPTIONAL) Enter the interface type and ID as one of the following:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
database (OPTIONAL) Enter the keyword database to display messages when there is a change
to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
1234 Routing Information Protocol (RIP)