Administrator Guide

Usage Information Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-defined profiles or
their default values. This command enables WRED configuration mode —(conf-wred).
Related
Commands
• threshold — specifies the minimum and maximum threshold values of the WRED profile.
DSCP Color Map Commands
The DSCP color map allows you to set the number of specific DSCP values to yellow or red. Traffic marked as yellow delivers traffic to the
egress queue which will either transmit the packet if it has available bandwidth or drop the packet due to no ability to send. Traffic marked
as red (high drop precedence) is dropped.
dscp
Sets the number of specific DSCP values for a color map profile to yellow or red.
Syntax
dscp {yellow | red} [list-dscp-values]
To remove a color policy map profile, use the no dscp {yellow | red} [dscp-list] command.
Parameters
Yellow Enter the yellow keyword. Traffic marked as yellow delivers traffic to the egress queue
which either transmits the packet if it has available bandwidth or drops the packet due to
no ability to send.
Red Enter the red keyword. Traffic marked as red is dropped.
dscp-list Enter a list of IP DSCP values. The dscp-list parameter specifies the full list of IP DSCP
value(s) for the specified color. Each DSCP value in a list is separate values by commas –
no spaces (1,2,3) or indicates a list of values separated by a hyphen (1-3). Range is 0 to
63.
Defaults None
Command Modes CONFIG-COLOR-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information If the specified color-map does not exist, the Diffserv Manager (DSM) creates a color map and sets all the DSCP
values to green (low drop precedence).
The default setting for each DSCP value (0-63) is green (low drop precedence). This command allows setting the
number of specific DSCP values to yellow or red.
Important Points to Remember
• All DSCP values that are not specified as yellow or red are colored green.
Quality of Service (QoS) 1227