Administrator Guide

interface Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
hash-mask-length (OPTIONAL) Enter the hash mask length. The range is from eight (8) to 128. The default
is 126.
priority (OPTIONAL) Enter the priority used in Bootstrap election process. The range is from zero
(0) to 255. In the BSR election process, the BSR with the higher priority takes the
precedence. If the priority values are equal, the router with the higher IP address becomes
the BSR. The default is 0.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the C9010, S3048-ON, S3100 Series, S4048-ON, S4048T-ON, S6000-ON,
S6010-ON, S6100-ON, Z9100-ON.
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces
contain the same designated router priority value, the interface with the largest interface IP address becomes the
designated router.
PIM-Sparse Mode (PIM-SM) 1141