Users Guide

Example
OS10# configure terminal
OS10(config)# ip pim vrf red bsr-candidate loopback 10 hash-mask-len 31
priority 11
Supported Releases 10.5.0.0 or later
ip pim bsr-candidate-timers
Congures the time interval between candidate BSR advertisements.
Syntax
ip pim [vrf vrf-name] bsr-candidate-timers {ethernet node/slot/port[:subport] |
loopback loopback-interface-number | vlan vlan-number | port-channel port-
channel-number} advt-interval interval-value
Parameters
• vrf vrf-name—Enter the keyword vrf, then the name of the VRF
• loopback-interface-number—Enter a value from 0 to 16383
• vlan-number—Enter a value from 1 to 4093
• port-channel-number—Enter a value from 1 to 128
• interval-value—Enter a value from 1 to 2147483
Default
• Advertisement interval default is 60 s.
Command Mode CONFIGURATION
Usage Information
Use this command to adjust the time interval between periodic BSR advertisements. The no form of the command
resets the candidate BSR advertisement interval to the default value. Do not specify the parameters in the no form
of the command.
Example
OS10(config)# ip pim vrf red bsr-candidate-timers loopback 10 advt-interval 40
Supported Releases 10.5.0.0 or later
ip pim bsr-timeout
Congures the BSR timeout value.
Syntax
ip pim [vrf vrf-name] bsr-timeout value
no ip pim [vrf vrf-name] bsr-timeout
Parameters
• vrf vrf-name—Enter the keyword vrf, then the name of the VRF
• value—Enter a value from 0 to 2147483
Default 130 s
Command Mode CONFIGURATION
Usage Information
The no form of the command resets the BSR timeout to its default value.
Multicast 725