Users Guide

Set group priority
The router that has the highest primary IP address of the interface becomes the master. The default priority for a virtual router is 100. If
the master router fails, VRRP begins the election process to choose a new master router based on the next-highest priority. The virtual
router priority is automatically set to 255, if any of the congured virtual IP addresses matches the interface IP address.
1 Create a virtual router for the interface with the VRRP identier in INTERFACE mode, from 1 to 255.
vrrp-group vrrp-id
2 Congure the priority number for the VRRP group in INTERFACE-VRRP mode, from 1 to 254, default 100.
priority number
Set VRRP group priority
OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)# vrrp-group 254
OS10(conf-eth1/1/5-vrid-254)# priority 200
Verify VRRP group priority
OS10(conf-eth1/1/5-vrid-254)# do show vrrp 254
Interface : ethernet1/1/5 IPv4 VRID : 254
Primary IP Address : 10.1.1.1 State : master-state
Virtual MAC Address : 00:00:5e:00:01:01
Version : version-3 Priority : 200
Preempt : Hold-time :
Authentication : no-authentication
Virtual IP address :
10.1.1.1
master-transitions : 1 advertise-rcvd : 0
advertise-interval-errors : 0 ip-ttl-errors : 0
priority-zero-pkts-rcvd : 0 priority-zero-pkts-sent : 0
invalid-type-pkts-rcvd : 0 address-list-errors : 0
pkt-length-errors : 0
Authentication
Simple authentication of VRRP packets ensures that only trusted routers participate in VRRP processes. When you enable authentication,
OS10 includes the password in its VRRP transmission. The receiving router uses that password to verify the transmission.
You must congure all virtual routers in the VRRP group with the same password. You must enable authentication with the same password
or authentication is disabled. Authentication for VRRPv3 is not supported.
1 Create a virtual router for the interface with the VRRP identier in INTERFACE mode, from 1 to 255.
vrrp-group vrrp-id
2 Congure a simple text password in INTERFACE-VRRP mode.
authentication-type simple—text text
simple—text text — Enter the keyword and a simple text password.
Congure VRRP authentication
OS10(config)# interface ethernet 1/1/5
OS10(conf-if-eth1/1/5)# vrrp-group 250
OS10(conf-eth1/1/5-vrid-250)# authentication simple-text eureka
680
Layer 3