Users Guide

PPID : TW09H9MN282987130026
Service Tag : 9531XC2
Product Base :
Product Serial Number:
Product Part Number :
License Details
----------------
Software : OS10-Enterprise
Version : 10.5.0.0
License Type : PERPETUAL
License Duration: Unlimited
License Status : Active
License location: /mnt/license/9531XC2.lic
---------------------------------------------------------
Troubleshoot license installation failure
An error message displays if the installation fails.
License installation failed
1 Verify the installation path to the local or remote license location.
2 Check the log on the remote server to nd out why the FTP or TFTP le transfer failed.
3 Ping the remote server from the switch — use the ping and traceroute commands to test network connectivity. Check the following
if the ping fails:
• If the remote server is reachable through the management route, check if the management route is congured correctly.
• If the remote server is reachable through a front-panel port, check if the static or dynamic route is present.
• If the ping is successful and the FTP or TFTP log on to a remote server does not register a response, check if there is a rewall in
the transfer path that is blocking the transfer protocol.
4 Install the server with the license le on the same subnet as the switch.
5 Check if the server is up and running.
Switch deployment options
After you log in to OS10, you can congure the switch:
• Manually by using the command-line interface
• Automatically using zero-touch deployment (ZTD)
• Automatically using customized scripts with Ansible
Manual CLI conguration
Use the OS10 command-line interface to enter commands to monitor and congure an OS10 switch. Set up your switch by performing
basic and advanced CLI tasks — CLI basics and Advanced CLI tasks. Then proceed with other conguration settings according to how you
deploy the switch in your network. For detailed conguration and CLI information, refer to the appropriate chapter.
ZTD-automated switch deployment
Automate OS10 switch deployment using zero-touch deployment, including:
• Upgrade an existing OS10 image.
• Execute a CLI batch le to congure the switch.
• Execute a post-ZTD script to perform additional functions.
See Zero-touch deployment.
Getting Started
49