Users Guide

Example
OS10(config)# spanning-tree mac-flush-timer 500
OS10(config)# no spanning-tree mac-flush-timer
Supported Releases 10.4.3.0 or later
spanning-tree mode
Enables an STP type: RSTP, Rapid-PVST+, or MST.
Syntax
spanning-tree mode {rstp | mst | rapid-pvst}
Parameters
• rstp — Sets STP mode to RSTP.
• mst — Sets STP mode to MST.
• rapid-pvst — Sets STP mode to RPVST+.
Default RPVST+
Command Mode CONFIGURATION
Usage Information All STP instances stop in the previous STP mode and restart in the new mode. You can also change to RSTP/MST
mode.
Example (RSTP)
OS10(config)# spanning-tree mode rstp
Example (MST)
OS10(config)# spanning-tree mode mst
Supported Releases 10.2.0E or later
spanning-tree port
Sets the port type as the EdgePort.
Syntax
spanning-tree port type edge
Parameters None
Default Not congured
Command Mode INTERFACE
Usage Information When you congure an EdgePort on a device running STP, the port immediately transitions to the Forwarding
state. Only congured ports connected to end hosts act as EdgePorts.
Example
OS10(config)# spanning-tree port type edge
Supported Releases 10.2.0E or later
show errdisable
Displays information on errdisable congurations and port recovery status.
Syntax
show errdisable [detect | recovery]
Parameters
• detect—Displays details of detect cause conguration.
Layer 2 405