Users Guide

Table Of Contents
Command Mode EXEC
Usage Information The counter default value resets to zero for all physical interfaces.
Example
OS10# clear lldp counters
Supported Releases 10.2.0E or later
clear lldp table
Clears LLDP neighbor information for all interfaces.
Syntax
clear lldp table
Parameters None
Default Not congured
Command Mode EXEC
Usage Information Neighbor information clears on all interfaces.
Example
OS10# clear lldp table
Supported Releases 10.2.0E or later
lldp enable
Enables or disables LLDP globally.
Syntax
lldp enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage Information This command enables LLDP globally for all Ethernet PHY interfaces, except on those interfaces where you
manually disable LLDP. The no version of this command disables LLDP globally irrespective of whether you
manually disable LLDP on an interface.
Example
OS10(config)# lldp enable
Supported Releases 10.3.1E or later
lldp holdtime-multiplier
Congures the multiplier value for the hold time in seconds.
Syntax
lldp holdtime-multiplier integer
Parameters integer — Enter the holdtime-multiplier value in seconds, from 2 to 10.
Default 4 seconds
Command Mode CONFIGURATION
378 Layer 2