Users Guide

Parameters zone-name — Enter a name for the zone.
Defaults Not congured
Command Mode
• CONFIGURATION
Usage Information
The no version of this command deletes the FC zone. To delete an FC zone, rst remove it from the FC zoneset.
Example
OS10(config)# fc zone hba1
OS10(config-fc-zone-hba1)# member wwn 10:00:00:90:fa:b8:22:19
OS10(config-fc-zone-hba1)# member wwn 21:00:00:24:ff:7b:f5:c8
Supported Releases 10.3.1E or later
fc zoneset
Creates an FC zoneset and adds the existing FC zones to the zoneset.
Syntax
fc zoneset zoneset-name
Parameters zoneset-name — Enter a name for the FC zoneset. The name must start with a letter and may contain these
characters: A-Z, a-z, 0-9, $, _, -, ^
Defaults Not congured
Command Mode
• CONFIGURATION
Usage Information
The no version of this command removes the FC zoneset.
Example
OS10(config)# fc zoneset set
OS10(conf-fc-zoneset-set)# member hba1
Supported Releases 10.3.1E or later
feature fc
Enables the F_Port globally.
Syntax
feature fc domain-id domain-id
Parameters domain-id — Enter the domain ID of the F_Port, from 1 to 239.
Defaults Disabled
Command Mode CONFIGURATION
Usage Information
The no version of this command disables the F_Port. You can disable the F_Port only when vfabric and zoning
congurations are not available. Before disabling the F_Port, remove the vfabric and zoning congurations. You can
enable only one of the following at a time: F_Port, NPG, or FSB.
Example
OS10(config)# feature fc domain-id 100
Supported Releases 10.3.1E or later
306 Fibre Channel