Users Guide

Example
OS10(config)# port-group 1/1/2
OS10(conf-pg-1/1/2)# profile restricted
Supported releases 10.4.3.0 or later
scale-prole vlan
Congures the L2 VLAN scale prole on a switch.
Syntax
scale-profile vlan
Parameters None
Defaults Not congured
Command Mode CONFIGURATION
Usage Information Use the VLAN scale prole when you scale the number of VLANs so that the switch consumes less memory.
Enable the scale prole before you congure VLANs on the switch. The scale prole globally applies L2 mode on all
VLANs you create and disables L3 transmission. The no version of the command disables L2 VLAN scaling. To
enable L3 routing trac on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported Releases 10.4.0E(X2) or later
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
• phy-eth node/slot/port[:subport] — Display information about physical ports connected to the
interface.
• status — Display interface status.
• ethernet node/slot/port[:subport] — Display Ethernet interface information.
• loopback id — Display Loopback IDs, from 0 to 16383.
• mgmt node/slot/port — Display Management interface information.
• null — Display null interface information.
• port-channel id-number — Display port channel interface IDs, from 1 to 128.
• vlan vlan-id — Display the VLAN interface number, from 1 to 4093.
Default Not congured
Command Mode EXEC
Usage Information Use the do show interface command to view interface information from other command modes.
Example
OS10# show interface
Ethernet 1/1/2 is up, line protocol is up
Hardware is Dell EMC Eth, address is 00:0c:29:54:c8:57
Current address is 00:0c:29:54:c8:57
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR 1.0M
Wavelength is 64
Interfaces 255