Users Guide

Table Of Contents
Default 0
Command Mode CONFIGURATION
Usage Information You cannot delete the Null interface. The only conguration command possible in a Null interface is ip
unreachables.
Example
OS10(config)# interface null 0
OS10(conf-if-nu-0)#
Supported Releases 10.3.0E or later
interface port-channel
Creates a port-channel interface.
Syntax
interface port-channel channel-id
Parameters channel-id — Enter the port-channel ID number, from 1 to 128.
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the interface.
Example
OS10(config)# interface port-channel 10
OS10(conf-if-po-10)#
Supported Releases 10.2.0E or later
interface range
Congures a range of Ethernet, port-channel, or VLAN interfaces for bulk conguration.
Syntax
interface range {ethernet node/slot/port[:subport]-node/slot/port[:subport],
[...]} | {port-channel IDnumber-IDnumber,[ ...]} | vlan vlanID-vlanID,[...]}
Parameters
node/slot/port[:subport]-node/slot/port[:subport] — Enter a range of Ethernet interfaces.
IDnumber-IDnumber — Enter a range of port-channel numbers, from 1 to 128.
vlanID-vlanID — Enter a range VLAN ID numbers, from 1 to 4093.
Default Not congured
Command Mode CONFIGURATION
Usage Information
Enter up to six comma-separated interface ranges without spaces between commas. When creating an interface
range, interfaces are not sorted and appear in the order entered. You cannot mix interface conguration such as
Ethernet ports with VLANs.
Abulk conguration is created if at least one interface is valid.
Non-existing interfaces are excluded from the bulk conguration with a warning message.
This command has multiple port ranges, the prompt excludes the smaller port range.
If you enter overlapping port ranges, the port range extends to the smallest port and the largest end port.
248 Interfaces