Users Guide

• Spaces between characters are not preserved after entering this command unless you enclose the entire
description in quotation marks; for example, “text description”.
• Enter a text string after the description command to overwrite any previously congured text string.
• Use the show running-configuration interface command to view descriptions congured for
each interface.
• The no version of this command deletes the description.
Example
OS10(conf-if-eth1/1/7)# description eth1/1/7
Supported Releases 10.2.0E or later
duplex
Congures Duplex mode on the Management port.
Syntax
duplex {full | half | auto}
Parameters
• full — Set the physical interface to transmit in both directions.
• half — Set the physical interface to transmit in only one direction.
• auto — Set the port to auto-negotiate speed with a connected device.
Defaults Not congured
Command Mode CONFIGURATION
Usage Information You can only use this command on the Management port. The no version of this command removes the duplex
mode conguration from the management port.
Example
OS10(conf-if-ma-1/1/1)# duplex auto
Supported Releases 10.3.0E or later
enable dom
Enables or disables the DOM feature.
Syntax
dom enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage Information The no version of this command disables digital optical monitoring.
Example
OS10# configure terminal
OS10(config)# dom enable
OS10# configure terminal
OS10(config)# no dom enable
Supported Releases 10.4.3.0 or later
244 Interfaces