Users Guide

Default Not congured
Command Mode DHCP-POOL
Usage Information Use the network command to congure the IPv4 or IPv6 subnet address from which the DHCP server may
assign addresses. The prex length for the mask is 18 to 31 bits.
Example
OS10(config-dhcp-Dell)# network 20.1.1.1/24
Supported Releases 10.2.0E or later
pool
Congures an IP address pool name.
Syntax
pool pool-name
Parameters pool-name — Enter the DHCP server pool name.
Default Not congured
Command Mode CONFIGURATION
Usage Information Use the pool command to name the pool of available IP addresses used by a DHCP server to assign an IP address
to a client and enter DHCP POOL mode. In this mode, use the network command to congure the IPv4 or IPv6
subnet from which the DHCP server assigns addresses.
Example
OS10(conf-dhcp)# pool Dell
OS10(conf-dhcp-Dell)#
Supported Releases 10.2.0E or later
range
Congures a range of IP addresses.
Syntax
range {ip-address1 [ip-address2]}
Parameters
• ip-address1 — First IP address of the IP address range.
• ip-address2 — Last IP address of the IP address range.
Default Not congured
Command Mode DHCP-POOL
Usage Information Use the range command to congure a range of IP addresses that the OS10 switch, acting as the DHCP server,
can assign to DHCP clients. The no version of this command requires only the rst IP address to remove the range
conguration.
Example
OS10(config)# OS10(config)# ip dhcp server
OS10(config-dhcp)# pool pool1
OS10(config-dhcp-pool1)# network 192.168.10.0/24
OS10(config-dhcp-pool1)# range 192.168.10.2 192.168.10.8
Supported Releases 10.4.1 or later
System management 191