Users Guide

snmp-server contact
Congures contact information for troubleshooting the local SNMP switch.
Syntax
snmp-server contact text
Parameters text — Enter an alphanumeric text string. A maximum of 55 characters.
Default The SNMP server contact is support.
Command Mode
• CONFIGURATION
Usage Information The no version of this command resets the SNMP server contact to the default value.
Example
OS10(config)# snmp-server contact administrator
Supported Releases 10.2.0E or later
snmp-server enable traps
Enables SNMP traps on a switch.
Syntax
snmp-server enable traps [notification-type] [notification-option]
Parameters
• notification-type notification-option — Enter an SNMP notication type, and optionally, a
notication option for the type.
Table 5. Notication types and options
Notication type Notication option
entity — Enable entity change traps. None
envmon — Enable SNMP environmental
monitor traps.
– fan — Enable fan traps.
– power-supply — Enable power-supply traps.
– temperature — Enable temperature traps.
lldp — Enable LLDP state change traps.
– rem-tables-change — Enable the
lldpRemTablesChange trap.
snmp — Enable SNMP traps.
– authentication — Enable authentication traps.
– coldstart — Enable coldstart traps when you power on
the switch and the SNMP agent initializes.
– linkdown — Enable link-down traps.
– linkup — Enable link-up traps.
– warmstart — Enable warmstart traps when the switch
reloads and the SNMP agent reinitializes.
Defaults Not congured
Command Mode
• CONFIGURATION
124 System management