Users Guide

Default Not congured
Command Mode EXEC
Usage Information
Use this command to check for a mismatch of MAC address table entries between VLT peers. Use this command
only when you observe network convergence issues. To verify VLT conguration mismatch issues on peer
switches, use the show vlt domain-name mismatch command.
Use this command if there are trac convergence issues.
Example
OS10# show vlt-mac-inconsistency
Checking Vlan 228 .. Found 7 inconsistencies .. Progress 100%
VLAN 128
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 1
----------
MAC 00:a0:c9:00:00:18 is missing from Node(s) 2
MAC 00:a0:c9:00:00:20 is missing from Node(s) 2
VLAN 131
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 132
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 135
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
VLAN 137
----------
MAC 00:00:00:00:00:02 is missing from Node(s) 2
Run "show vlt mismatch ..." commands to identify configuration issues
Supported Releases 10.2.0E or later
show vlt mismatch
Displays mismatches in a VLT domain conguration.
Syntax
show vlt id mismatch [dhcp-snooping | peer-routing | vlan | vlt-vlan vlt-port-
id | virtual-network]
Parameters
• id — Enter the VLT domain ID, from 1 to 255.
• dhcp-snooping — Display mismatches in a DHCP snooping conguration in a VLT domain.
• peer-routing — Display mismatches in the peer-routing conguration.
• vlan — Display mismatches in a VLAN conguration in the VLT domain.
• vlt-vlan vlt-port-id — Display mismatches in the VLT port conguration, from 1 to 4095.
• virtual-network — Display mismatches in virtual network congurations between VLT peers.
Default Not congured
Command Mode EXEC
Usage Information The * in the mismatch output indicates a local node entry.
Example (no
mismatch)
OS10# show vlt 1 mismatch
Peer-routing mismatch:
No mismatch
1222 Virtual Link Trunking