Users Guide

Supported Releases 10.3.0E or later
discovery-interface
Congures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers.
Syntax
discovery-interface {ethernet node/slot/port[:subport]}
Parameters ethernet — Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of
interfaces separated by hyphens and commas.
Default None
Command Mode VLT-DOMAIN
Usage Information The VLT node discovery service automatically connects the discovery port to its peer node port and creates VLTi
interfaces. The no version of this command disables the discovery-interface conguration.
Example
OS10(config)# vlt-domain 1
OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15
Example (range)
OS10(config)# vlt-domain 2
OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12
Supported Releases 10.2.0E or later
peer-routing
Enables optimized routing where packets destined for the L3 endpoint of the VLT peer are locally routed.
Syntax
peer-routing
Parameters None
Default Disabled
Command Mode VLT-DOMAIN
Usage Information The no version of this command disables peer routing.
Example
OS10(conf-vlt-1)# peer-routing
Supported Releases 10.2.0E or later
peer-routing-timeout
Congures the delay after which, the system disables peer routing when the peer is not available. This command supports both IPv6 and
IPv4 routing.
Syntax
peer-routing-timeout value
Parameters value — Enter the timeout value in seconds, from 0 to 65535.
Default 0
Command Mode VLT-DOMAIN
Virtual Link Trunking 1217