Users Guide

hardware deep-buer-mode
Congures Deep Buer mode.
Syntax
hardware deep-buffer-mode
Parameters None
Defaults Disabled
Command Modes CONFIGURATION
Usage Information
Deep Buer mode conguration takes eect only after you save it in the startup conguration and reboot the
switch. The no version of this command disables Deep Buer mode.
Example
OS10(config)# hardware deep-buffer-mode
Supported Releases 10.4.3.0 or later
match
Congures match criteria for the QoS policy.
Syntax
match {cos cos-number | ip [access-group name name | dscp dscp-value [ecn ecn-
value] | precedence value] | ip-any [dscp dscp-value [ecn ecn-value] |
precedence value] | ipv6 [access-group name name | dscp dscp-value [ecn ecn-
value] | precedence value] | mac access-group acl-name | not [cos | ip | ip-any
| ipv6] | vlan vlan-id}
Parameters
• cos cos—number — Enter a queue number for the CoS match criteria, from 0 to 7.
• ip — Enter the IPv4 match criteria.
• access-group name name — (Optional) Enter the IPv4 access-group name.
• dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
• ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
• precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7.
• ip-any — Enter the IPv4 or IPv6 match criteria.
• dscp dscp-value — (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63.
• ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
• precedence value — (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7.
• ipv6 — Enter the IPv6 match criteria.
• access-group name name — (Optional) Enter the IPv6 access-group name.
• dscp dscp-value — (Optional) Congure a DSCP value for L3 DSCP match criteria, from 0 to 63.
• ecn ecn-value — (Optional) Enter a ECN value for ECN bit match criteria, from 0 to 3.
• mac access-group name name — Enter an access-group name for the MAC access-list match criteria.
A maximum of 140 characters.
• dscp dscp-value — Enter a DSCP value for marking the DSCP packets, from 0 to 63.
• not — Enter the IP or CoS to negate the match criteria.
• vlan vlan-id — Enter a VLAN number for VLAN match criteria, from 1 to 4093.
Quality of service
1157