Users Guide

Parameters
• sequence-number — Enter the sequence number to identify the ACL for editing and sequencing number,
from 1 to 16777214.
• protocol-number — (Optional) Enter the protocol number, from 0 to 255.
• icmp — (Optional) Enter the ICMP address to deny.
• ip — (Optional) Enter the IPv4 address to deny.
• tcp — (Optional) Enter the TCP address to deny.
• udp — (Optional) Enter the UDP address to deny.
• A.B.C.D — (Optional) Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — (Optional) Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not congured
Command Mode IPV4-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter, or use the no seq sequence-number command if you know
the lter’s sequence number.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# seq 10 deny tcp any any capture session 1 log
Supported Releases 10.2.0E or later
seq deny (IPv6)
Assigns a sequence number to deny IPv6 addresses while creating the lter.
Syntax
seq sequence-number deny [protocol-number icmp | ip | tcp | udp] [A::B | A::B/x
| any | host ipv6-address] [A::B | A::B/x | any | host ipv6-address] [capture |
count | dscp value | fragment | log]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• protocol-number — (Optional) Enter the protocol number, from 0 to 255.
• icmp — (Optional) Enter the ICMP address to deny.
• ip — (Optional) Enter the IPv6 address to deny.
• tcp — (Optional) Enter the TCP address to deny.
• udp — (Optional) Enter the UDP address to deny.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
1078 Access Control Lists