Users Guide

• syn — (Optional) Set the bit as synchronize.
• urg — (Optional) Set the bit set as urgent.
• capture — (Optional) Capture packets the lter processes.
• count — (Optional) Count packets the lter processes.
• byte — (Optional) Count bytes the lter processes.
• dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
• fragment — (Optional) Use ACLs to control packet fragments.
• log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
• operator — (Optional) Enter a logical operator to match the packets on the specied port number. The
following options are available:
– eq — Equal to
– gt — Greater than
– lt — Lesser than
– neq — Not equal to
– range — Range of ports, including the specied port numbers.
Default Not congured
Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter.
Example
OS10(conf-ipv6-acl)# permit udp any any capture session 1 count
Supported Releases 10.2.0E or later
remark
Species an ACL entry description.
Syntax
remark description
Parameters description — Enter a description. A maximum of 80 charaters.
Default Not congured
Command Mode IPV4-ACL
Usage Information Congure up to 16777214 remarks for a given IPv4, IPv6, or MAC. The no version of the command removes the
ACL entry description.
Supported Releases 10.2.0E or later
seq deny
Assigns a sequence number to deny IPv4 addresses while creating the lter.
Syntax
seq sequence-number deny [protocol-number | icmp | ip | tcp | udp] [A.B.C.D |
A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-
address] [capture | count | dscp value | fragment | log]
Access Control Lists 1077