Users Guide

ip access-group
Congures an IPv4 access group.
Syntax
ip access-group access-list-name {in | out}
Parameters
• access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
• in — Apply the ACL to incoming trac.
• out — Apply the ACL to outgoing trac.
Default Not congured
Command Mode
INTERFACE
CONTROL-PLANE
Usage Information Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are only
applied on the ingress trac. By default, the control-plane ACL is applied to the front-panel ports as well as the
management port.The no version of this command deletes the IPv4 ACL conguration.
Example
OS10(conf-if-eth1/1/8)# ip access-group testgroup in
Example (Control-
plane ACL)
OS10# configure terminal
OS10(config)# control-plane
OS10(config-control-plane)# ip access-group aaa-cp-acl in
Supported Releases 10.2.0E or later; 10.4.1 or later (control-plane ACL)
ip access-list
Creates an IP access list to lter based on an IP address.
Syntax
ip access-list access-list-name
Parameters access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# ip access-list acl1
Supported Releases 10.2.0E or later
ip as-path access-list
Create an AS-path ACL lter for BGP routes using a regular expression.
Syntax
ip as-path access-list name {deny | permit} regexp-string
1060 Access Control Lists