Administrator Guide
Parameters
seconds Enter a value from 5 to 3600 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(2.5) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6010–ON and Z9100–ON
Usage Information
SNMP notication for the changes in the lldp remote entry table is throttled by 5 seconds (default), or the
congured time set using this command. If more than one notication message is generated within the congured
time, only the rst one will be sent and the remaining messages are suppressed.
LLDP-MED Commands
The following are the LLDP-MED (Media Endpoint Discovery) commands.
Dell Networking OS LLDP-MED commands are an extension of the set of LLDP TLV advertisement commands.
As dened by ANSI/TIA-1057, LLDP-MED provides organizationally specic TLVs (Type Length Value), so that endpoint devices and
network connectivity devices can advertise their characteristics and conguration information. The Organizational Unique Identier (OUI)
for the Telecommunications Industry Association (TIA) is 00-12-BB.
• LLDP-MED Endpoint Device — any device that is on an IEEE 802 LAN network edge, can communicate using IP, and uses the LLDP-
MED framework.
• LLDP-MED Network Connectivity Device — any device that provides access to an IEEE 802 LAN to an LLDP-MED endpoint device,
and supports IEEE 802.1AB (LLDP) and TIA-1057 (LLDP-MED). The Dell Networking system is an LLDP-MED network connectivity
device.
Regarding connected endpoint devices, LLDP-MED provides network connectivity devices with the ability to:
• manage inventory
• identify physical location
• identify network policy
advertise med guest-voice
To advertise a separate limited voice service for a guest user with their own IP telephony handset or other appliances that support
interactive voice services, congure the system.
Syntax
advertise med guest-voice {vlan-id layer2_priority DSCP_value} | {priority-
tagged number}
To return to the default, use the no advertise med guest-voice {vlan-id layer2_priority
DSCP_value} | {priority-tagged number} command.
974 Link Layer Discovery Protocol (LLDP)