Administrator Guide

number ipmacacl
number ecfmacl
number
{nlbclusteracl]
[vman-qos | vman-
dual-qos number]
ipv4pbr
numberopenow
{4|8} | fcoe number
[iscsioptacl number]
[vrfv4acl number]
• 8: Creates 498 entries for use by the OpenFlow controller (512 total entries minus the
14 entries reserved for internal functionality)
The fcoe range is 0–6 groups. Each group has 128 entries; the value given must be an
even number. This information is stored in the NVRAM and is eective after rebooting the
switch.
[ipv4mirracl
Enter the ipv4mirracl keyword and then the number of FP blocks for IPv4 mirror
ACL. The range is from 0 to 8. You cannot use the ipv4mirracl and
ipv4udfmirracl commands at the same time.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.12(0.0) Added the keyword ipv4mirracl.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Claried block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the system
for the new settings to take eect.
The total amount of space allowed is 16 FP Blocks. System ow requires three blocks; these blocks cannot be
reallocated. Only 13 number of blocks can be congured by the user .
474 Content Addressable Memory (CAM)