Users Guide

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Management interface, enter the keyword managementethernet followed by
slot/port numbers.
• For a Port Channel interface, enter the keywords port-channel followed by a number.
• For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.3(0.0) Added support for multicast MAC address on the MXL platform.
Example (Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range gi
1/2,gi 1/3
ip vlan-ooding
Enable unicast data trac ooding on VLAN member ports.
Syntax
ip vlan-flooding
To disable, use the no ip vlan-flooding command.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL platforms.
Default Disabled
Usage Information By default this command is disabled. There might be some ARP table entries which are resolved through ARP
packets which had Ethernet MAC SA dierent from MAC information inside the ARP packet. This unicast data
trac ooding occurs only for those packets which use these ARP entries.
Microsoft Network Load Balancing 923