Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on E-Series.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the vlan option on the E-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Added support for the violate-action and detail options.
6.5.1.0 Added support for Port Channel.
Example
Dell# show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/1 10 0 0 0
Gi 1/2 5 0 0 0
Dell#show mac learning-limit interface gigabithethernet 1/1
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/1 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands congure and monitor virtual LANs (VLANs). VLANs are a virtual interface and use many of the same commands
as physical interfaces.
You can congure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are not
supported on a VLAN.
Occasionally, while sending broadcast trac over multiple Layer 3 VLANs, the VRRP state of a VLAN interface may continually switch
between Master and Backup.
NOTE
: For more information, refer to VLAN Stacking and VLAN-related commands, such as portmode hybrid in the Interfaces
chapter.
default vlan-id
Specify a VLAN as the Default VLAN.
Syntax
default vlan-id vlan-id
Layer 2 877