Users Guide

mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology change.
Syntax
mac-address-table station-move refresh-arp
To disable the ARP refresh feature, use the no mac-address-table station-move refresh-arp
command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.9(0.0) Modied the default option from none to Enabled.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage Information For more information about using this command, see NIC Teaming in the Layer 2 section of the Dell Networking
OS Conguration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
Syntax
mac learning-limit address_limit [vlan vlan-id] [station-move-violation
[dynamic]] [dynamic [no-station-move| station-move]]
Parameters
address_limit Enter the maximum number of MAC addresses that can be learned on the interface. The
range is from 1 to 1000000.
864 Layer 2