Users Guide

summary (OPTIONAL) Enter the keyword summary to display a table listing network prexes and
the total number prexes which can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have more
specic prexes. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
Usage Information
NOTE: If a route has a mask greater than 64, no output is displayed and no output is displayed for show
ipv6 cam stack-unit unit-number port-set {0-1} ipv6-address, but an
equivalent /64 entry would be listed in the
show ipv6 cam stack-unit unit-number port-
set {0-1} output. Similarly, if there is more than one ECMP object with a destination route that has a
mask greater than 64, if the rst 64 bits in the destination routes of the ECMP objects are the same,
only one route is installed in CAM even though multiple ECMP path entries exist.
NOTE: The self address is displayed in the neighbor portion for the show ipv6 cam stack-unit
unit-number port-set command.
show ipv6 control-plane icmp
Displays the status of the icmp control-plane setting for the error eate limit setting.
Syntax
show ipv6 control-plane icmp
Default 100
Command Modes EXEC
780 IPv6 Basics