Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Added support for 4093 VLANs on E-Series. Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information When creating an interface range, interfaces appear in the order they are entered; they are not sorted. The
command veries that interfaces are present (physical) or congured (logical).
Important Points to Remember:
• Bulk conguration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk conguration with a warning message.
• The interface range prompt includes interface types with slot/port information for valid interfaces. The
prompt allows for a maximum of 32 characters. If the bulk conguration exceeds 32 characters, it is
represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port range is excluded from the
prompt.
• If overlapping port ranges are specied, the port range is extended to the smallest start port and the biggest
end port.
Example (Bulk)
Dell(conf)# interface range gigbitethernet 1/1 - 1/11, tengigabitethernet 3/3,
gigbitethernet 3/10
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
Dell(conf)# interface range gigabitethernet 2/10 - 2/23, gigabitethernet 2/12
- 2/17
Dell(conf-if-range-gi-2/10-2/23)#
Example
(Overlapping Ports)
Dell(conf)# interface range gigabitethernet 2/3 - 2/11, gigabitethernet 2/3 -
2/23
Dell(conf-if-range-gi-2/3-2/23)#
Usage Information
Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel
commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-
channel interfaces that are not displayed in the show running-config command cannot be used with the bulk
conguration feature of the
interface range command. You cannot create virtual interfaces (VLAN, Port-
channel) using the interface range command.
Interfaces 617