Users Guide

Version Description
9.9(0.0) Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000–ON,
and Z9500.
Usage Information
Use the default interface command to set a Gigabit Ethernet, 10- Gigabit Ethernet, or 40-Gigabit Ethernet
interface to its factory-default state. By default, a physical interface is disabled (shutdown) with no assigned IP
address or switchport (no ip address). This command removes all software settings and all L3, VLAN, VXLAN, and
port-channel congurations on a physical interface.
Example
Dell(conf-if-gi-1/5)# show config
!
interface GigabitEthernet 1/5
description testconfig
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
Dell(conf-if-gi-1/5)#
Dell(conf)# default interface gigabitethernet 1/5
Dell(conf-if-gi-1/5)# show config
!
interface GigabitEthernet 1/5
no ip address
shutdown
Related Commands
• show running-cong – display the current conguration.
description
Assign a descriptive text string to the interface.
Syntax
description desc_text
To delete a description, use the no description command.
Parameters
desc_text Enter a text string up to 240 characters long.
Defaults None
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
606 Interfaces