Users Guide
PROTOCOL GVRP Mode
To enable and congure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, see GARP VLAN
Registration (GVRP).
To enter PROTOCOL GVRP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol gvrp command. The prompt changes to include config-gvrp.
You can return to CONFIGURATION mode by using the exit command.
RAPID SPANNING TREE (RSTP) Mode
To enable and congure RSTP, use RSTP mode. For more information, see Rapid Spanning Tree Protocol (RSTP).
To enter RSTP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2
Enter the protocol spanning-tree rstp command. The prompt changes to include conf-rstp.
You can return to CONFIGURATION mode by using the exit command.
ROUTE-MAP Mode
To congure a route map, use ROUTE-MAP mode.
To enter ROUTE-MAP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the route-map map-name [permit | deny] [sequence-number] command. The prompt changes to include
config-route-map.
You can return to CONFIGURATION mode by using the exit command.
ROUTER BGP Mode
To enable and congure Border Gateway Protocol (BGP), use ROUTER BGP mode. For more information, see Border Gateway Protocol
IPv4 (BGPv4)
To enter ROUTER BGP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the router bgp command, and then enter the AS number. The prompt changes to include conf-router_bgp.
You can return to CONFIGURATION mode by using the exit command.
ROUTER ISIS Mode
To enable and congure Intermediate System to Intermediate System (ISIS), use ROUTER ISIS mode. For more information, see
Intermediate System to Intermediate System (IS-IS).
To enter ROUTER ISIS mode:
CLI Basics
53