Users Guide
distance bgp
Congure three administrative distances for routes.
Syntax
distance bgp external-distance internal-distance local-distance
To return to default values, use the no distance bgp command.
Parameters
external-distance Enter a number to assign to routes learned from a neighbor external to the AS. The range
is from 1 to 255. The default is 20.
internal-distance Enter a number to assign to routes learned from a router within the AS. The range is from
1 to 255. The default is 200.
local-distance Enter a number to assign to routes learned from networks listed in the network command.
The range is from 1 to 255. The default is 200.
Defaults
• external-distance = 20
• internal-distance = 200
• local-distance = 200
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
CAUTION: Dell Networking recommends not changing the administrative distance of internal routes.
Changing the administrative distances may cause routing table inconsistencies.
The higher the administrative distance assigned to a route means that your condence in that route is low. Routes
assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are
treated as internal BGP routes.
Related Commands
• router bgp — enter ROUTER mode on the switch.
430 Border Gateway Protocol