Users Guide

copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port
is the monitored port (MD) and the destination port is the monitoring port (MG).
Related Commands
• deny tcp — assign a lter to deny TCP packets.
• deny udp — assign a lter to deny UDP packets.
• ip access-list extended — create an extended ACL.
seq (for Standard IPv4 ACLs)
Assign a sequence number to a deny or permit lter in an IP access list while creating the lter.
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host ip-address}}
[count [bytes]] [dscp value] [order] [fragments] [log [interval minutes]
[threshold-in-msgs [count]] [monitor]
To delete a lter, use the no seq sequence-number command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes. By default, ow-based monitoring is not
enabled.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4(0.0) Added support for ow-based monitoring on the S4810, S4820T, S6000, and Z9000
platforms.
9.3(0.0) Added support for logging of ACLs on the S4810, S4820T, and Z9000 platforms.
262 Access Control Lists (ACL)