Users Guide

• A successful match with a continue clause, the route map executes the set clauses and then goes to the
specied route map entry upon execution of the continue clause.
• If the next route map entry contains a continue clause, the route map executes the continue clause if a
successful match occurs.
• If the next route map entry does not contain a continue clause, the route map evaluates normally. If a match
does not occur, the route map does not continue and falls through to the next sequence number, if one exists.
Set Clause with Continue Clause
If the route-map entry contains sets with the continue clause, set actions are performed rst then the continue
clause jumps to the specied route map entry.
• If a set action occurs in the rst route map entry and then the same set action occurs with a dierent value in
a subsequent route map entry, the last set of actions overrides the previous set of actions with the same set
command.
• If set community additive and set as-path prepend are congure, the communities and AS
numbers are prepended.
Related Commands
• set community — specify a COMMUNITY attribute.
• set as-path — congure a lter to modify the AS path.
description
Add a description to this route map.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the route map (80 characters maximum).
Defaults None
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
232 Access Control Lists (ACL)