Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1601

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage Information

This command applies to all the VRRP interfaces on a system. When you use this command with the vrrp

delay minimum command, the later timer rules VRRP enabling. For example, if vrrp delay reload is 600

and

vrrp delay minimum is 300:

• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up

and congured for VRRP.

• When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300

seconds (5 minutes) to bring up VRRP on that interface.

For the delay timers to take eect, save the conguration and reload the system.

Related Command

• vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.

vrrp-group

Assign a VRRP ID to an interface. You can congure up to 12 VRRP groups per interface.

Syntax

vrrp-group vrrp-id

Parameters

vrrp-id Enter a number as the group ID. The range is from 1 to 255.

Defaults Not congured.

Command Modes INTERFACE