Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the same, a syslog
message generates and VLT does not launch.
Related Commands
• show vlt brief — display the delay-restore value.
vlt-peer-lag port-channel
Associate the port channel to the corresponding VLT peer port channel for the VLT connection to an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number Enter the respective VLT port-channel number of the peer device. The range is from 1 to
128.
Defaults Not congured.
Command Modes INTERFACE PORT-CHANNEL
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
show vlt private-vlan
Display the private VLAN (PVLAN) associated with the VLT LAG for VLT peer nodes.
Syntax
show vlt private-vlan
Command Modes EXEC
Virtual Link Trunking (VLT) 1591