Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1571

To disable L3 VLT peer-routing, use the no peer-routing command.

Defaults Disabled.

Command Modes VLT DOMAIN (conf-vlt-domain)

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.4(0.0) Added the support for IPV6 / IPV4.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux

(PMUX) mode only.

9.2(0.2) Introduced on the Z9000, S4810, and S4820T.

peer-routing-timeout

Congure the delay after which peer routing disables when the peer is unavailable. This command is applicable for both IPv6 and IPv4.

Syntax

peer-routing-timeout value

To restore the default value, use the no peer-routing-timeout command.

Parameters

value Enter the timeout value (in seconds). The range is from 1 to 65535. The default value is

innity.