Users Guide

stack-unit provision
Precongure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management unit.
Syntax
stack-unit [stack-number] provision {model-identifier}
Parameters
stack-number Enter a stack member identier of the switch that you want to add to the stack.
model-identier Enter the model identier of the switch to be added as a stack member. This identier is
also referred to as the provision type.
Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identier.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related Commands
• reload – reboot the Dell Networking OS.
• show system (S-Series and Z-Series) – display the status of all stack members or a specic member.
stack-unit stack-group
Congure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the
correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group conguration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID.
Defaults none
Command Modes CONFIGURATION
Stacking 1459