Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Added support for the access parameter.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following example species the group named harig as a version 3 user requiring both authentication and
encryption and read access limited to the read named rview.
NOTE: The number of congurable groups is limited to 16
groups.
Example
Dell# conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related Commands
• show snmp group — displays the group name, security model, view status, and storage type of each group.
• show running-cong — displays the SNMP running conguration.
snmp-server host
Congure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps | informs
[version 1 | 2c | 3] [auth | no auth | priv] [community-string] [udp-port port-
number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [vrf vrf-name] traps |
informs [version 1 | 2c | 3] [auth | noauth | priv] [community-string] [udp-
port number] [notification-type] command.
Parameters
ip-address Enter the keyword host then the IP address of the host (congurable hosts is limited to
16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zero.
vrf vrf-name Enter the keyword vrf and then the name of the VRF that the SNMP server uses to
connect to the host.
1412 Simple Network Management Protocol (SNMP) and Syslog