Users Guide

Version Description
7.4.1.0 Introduced on the E-Series.
Usage Information Sample-rate is the average number of packets skipped before the sample is taken. This command changes the
global default sampling rate. You can congure an interface to use a dierent sampling rate than the global
sampling rate. If the value entered is not a correct power of 2, the command generates an error message with the
previous and next power of 2 value. Select one of these two packet numbers and re-enter the command.
Related Commands
• sow sample-rate (Interface) — changes the interface sampling rate.
sow sample-rate (Interface)
Change the interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series, the range is from 256 to
8388608 packets. Enter values in powers of 2 only; for example, 4096, 8192, 16384, etc.
The default is 32768 packets.
Defaults The Global default sampling.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set to the
same value as the current global default sampling rate. If the value entered is not a correct power of 2, the
sFlow 1397