Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Expanded the command to permit conguration on port channels.
6.1.1.1 Introduced on the E-Series.
Usage Information
To honor all incoming 802.1p markings on incoming switched trac on the interface, enter this command. By
default, this facility is not enabled (that is, the 802.1p markings on incoming trac are not honored).
You can apply this command on both physical interfaces and port channels. When you set the service-class
dynamic for a port channel, the physical interfaces assigned to the port channel are automatically congured; you
cannot assign the service-class dynamic command to individual interfaces in a port channel.
• All dot1p trac is mapped to Queue 0 unless you enable the service-class dynamic dot1p command
on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
strict-priority queue
Congure a unicast queue as a strict-priority (SP) queue.
S3048–ON
Syntax
strict-priority queue unicast number
Parameters
unicast number Enter the keyword unicast then the queue number. The range is from 1 to 3.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Quality of Service (QoS) 1183