Users Guide
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.
8.3.11.1 Introduced on the Z9000
8.2.1.0 Increased number of VLANs to 4094 (was 2094)
8.1.1.0 Introduced on E-Series
7.6.1.0 Support added for S-Series
7.5.1.0 Introduced on C-Series
ip http vrf
Congure an HTTP client with a VRF used to connect to the HTTP server.
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client conguration, use the ip http vrf command.
Parameters
management Enter the keyword management for conguring the management VRF that uses an
HTTP client.
vrf-name Enter a VRF name that the HTTP client uses. If you do not specify a VRF name, the
HTTP client uses the default VRF.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Control and Monitoring 101