Service Manual

distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a lter.
S3048–ON
Syntax
distribute-list prefix-list-name out [bgp | connected | isis | rip |
static]
To remove a lter, use the no distribute-list prefix-list-name out [bgp | connected
| isis | rip | static] command.
Parameters
prex-list-name Enter the name of a congured prex list.
bgp (OPTIONAL) Enter the keyword bgp to specify that BGP routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS,
and RIP routes are not available on the S-Series.
connected (OPTIONAL) Enter the keyword connected to specify that connected routes are
distributed.
isis (OPTIONAL) Enter the keyword isis to specify that IS-IS routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS,
and RIP routes are not available on the S-Series.
rip (OPTIONAL) Enter the keyword rip to specify that RIP routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS,
and RIP routes are not available on the S-Series.
static (OPTIONAL) Enter the keyword static to specify that only manually congured
routes are distributed.
Defaults Not congured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)
999