Service Manual
35
Multicast
The multicast commands are supported by Dell Networking operating system (OS) on all S3048–ON platform.
This chapter contains the following sections:
• IPv4 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information
base, use the
clear ip pim tib command.
Syntax
clear ip mroute [vrf vrf-name] {group-address [source-address] | * |
snooping}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
group-address
[source-address]
Enter the multicast group address and source address (if desired), in dotted
decimal format, to clear information on a specic group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping route table entries.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for keyword snooping on the Z9000, S4810, and S4820T.
944
Multicast